Operation Manual

RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 9.9
“XXX” indicates the value currently in memory, while “000” is the new value to be modified. After
entering the desired value using the number keys, press ENTER to confirm.
9.5.4. LUBRICATION DURATION
This option is used for configuring the duration of an automatic lubrication cycle. The following
message appears on the LCD:
L E N G T H O F L U B R I C A T .
S e c . = X XX
“XX” indicates the value currently in memory, while “000” is the new value to be modified. After
entering the desired value using the number keys, press ENTER to confirm.
At the end of the procedure the machine reverts to standby mode.
If the machine is not equipped with an automatic lubrication cycle, the lubrication
parameters are not significant.
Downloaded from www.Manualslib.com manuals search engine