Operation Manual

RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 9.8
9.5. MODIFYING THE WORKING PARAMETERS
The procedure for setting the values of the machine’s working parameters (for example, after having
replaced the CPU board) is accessed by simultaneously pressing the 01 keys when the machine is in
standby mode. The following message appears on the LCD:
P A S S W O R D = 0 0 0 0
T H E N E N T E R O R C L E A R
Type in the password 2406 and press ENTER to confirm. This accesses the configuration procedure
for sequentially modifying the following parameters.
This procedure can be used on machines equipped with the automatic lubrication
system, for fine tuning the parameters which determine the frequency and duration of
the lubrication cycle.
Press the “Clear” key to exit the procedure at any time. The changes made will remain
valid.
9.5.1. TOTAL HOURS
This option is used for entering the desired number of working hours. The following message
appears on the display:
T O T A L H O U R S =
X X X X - > 0 0 0 0 0
“XXXX” indicates the value currently in memory, while “00000” is the new value to be entered.
After entering the desired new value using the number keys, press ENTER to confirm.
9.5.2. DISTANCE COVERED
This option is used for entering the distance covered by the machine. The following message
appears on the LCD:
K m . C O V E R E D =
X X X X - > 0 0 0 0 0
“XXXX” indicates the value currently in memory, while “00000” is the new value to be modified.
After entering the desired value using the number keys, press ENTER to confirm.
9.5.3. LUBRICATION INTERVAL
This option is used for setting the number of kilometers between 2 successive lubrication cycles.
The following message appears on the LCD:
L U B R I C A T I O N T I M E .
K m .= XX X -> 0 00
Downloaded from www.Manualslib.com manuals search engine