Operation Manual

RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 9.4
9.3. PARTIAL DISPLAY OF WORKING PARAMETERS
In order to check the state of wear of the machine and correctly carry out routine machine
maintenance, a special procedure is provided for viewing the values of the working parameters. This
is a “partial” procedure in that the lubrication parameters shown are only those pertaining to the
type.
To access this procedure, simultaneously press the 03 keys when the machine is in standby mode.
The following message will appear on the LED matrix display:
P A S S W O R D = 0 0 0 0
T H E N E N T E R O R C L E A R
Type in the password 6144 and press ENTER to confirm.
9.3.1. MACHINE UTILIZATION
The total hour count of machine on-time and the total kilometers covered. The following message
appears on the LCD:
T O T A L H O U R S = X X X X
K m . C O V E R E D = X X X X
After 10 seconds, it automatically goes on to the next view.
The procedure can be aborted at any time by pressing the “Clear” key.
9.3.2. TYPE OF LUBRICATION
The type of lubrication setting: Weak, Medium or Strong. The following message appears on the
display:
L U B R I C A T I O N :
X X XX XX
After 10 seconds, it automatically goes on to the next view.
9.3.3. DISTANCE COVERED SINCE THE LAST LUBRICATION
The number of kilometers covered by the machine since the last automatic lubrication procedure.
The following message appears on the LCD:
K m . C O V E R E D F R O M
L A S T L U B R I C A T . = X X X X
After 10 seconds, it automatically goes on to the next view.
Downloaded from www.Manualslib.com manuals search engine