Operation Manual

RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 7.12
7.10. DISASSEMBLING THE FRONT PLATE
Figure 7.10-1
Carry out the procedure described in paragraph
7.8. “Disassembling the motor guard”.
1. Back off the 4 screws a using a 6-mm hex T
wrench.
2. Remove the 2 side plugs b.
3. Back off the 4 self-tapping screws c using a
large Philips screwdriver.
4. Rotate the FRONT PLATE d downward.
The front plate remains attached to the
frame by means of two steel cables.
To reassemble the FRONT PLATE, carry out the
above steps in reverse order.
Downloaded from www.Manualslib.com manuals search engine