Operation Manual

RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 7.10
7.8. DISASSEMBLING THE MOTOR GUARD
Figure 7.8-1
1. Turn off the machine and unplug the mains
lead from the wall outlet.
2. Back off the 6 screws a using a large Philips
screwdriver.
3. Raise the MOTOR GUARD b.
Figure 7.8-2
To retain the MOTOR GUARD in the
raised position, use the elastic strap
provided inside the guard itself, as
shown in figure at left.
To reassemble the MOTOR GUARD, carry out
the above steps in reverse order.
Figure 7.8-3
The MOTOR GUARD can also be removed
completely, in order to work more freely inside
the machine:
1. On each side, back off the dowel c using a 3-
mm hex T wrench.
2. Back off screw d with an 8-mm hex T
wrench.
3. Remove the bar guard by lifting it upward.
4. Lift up the MOTOR GUARD.
It is advisable to reassemble the bar
guard to protect against soiling from the
elevation bars.
Downloaded from www.Manualslib.com manuals search engine