Operation Manual

19
Recline Artis
A
Electrical connection (mains powered version)
Before connecting the equipment to the mains power supply, ensure that the electrical system specications comply to binding regulations. Verify the main
power supply specications on the label axed close to the main switch.
Open panel (A) to reach the label and connector: put a nger in the hole and pull.
W
The wall socket must be located in a place where the plugging and unplugging can be done easily and safely.
When plugging in, the switch on the equipment must be in the 0 position (i.e. the equipment must be switched o).
Plug the power cable rst into the equipment socket and then into the wall socket.
Close panel (A) putting the cable through the slot.