Operation Manual

21
A
JOG FORMA
Aligning the treadmill
When the equipment is running the treadmill must be centrally aligned in relation
to the frame. If it tends to move to the right or left or is not centrally positioned, it
needs aligning.
The alignment is done with the equipment running.
Set the adjustment screw (A), located at the back of the equipment, opposite the
control panel support riser, so that the belt is centrally aligned with the back roller.
The treadmill realigns slowly: turn the adjustment screw 1/4 or 1/2 a turn and
then check the result before turning it again.
Maximum allowed running
surface lateral position:
17 mm ± 5 mm