Product Manual

We recycle for a better world
www.technoflex.ca
How to install parking curbs?
I. Drill holes into the asphalt through the holes already in the rubber parking
curb. Make sure the holes are at least ½ inch wide and 3-4 inches deep.
II. Drive the ½ inch rebar spike through the holes in the rubber parking curb.
Rebar Spikes should be 14 inches long.
III. Leave the rubber parking curb undisturbed for a minimum of 12 hours.
Rubber parking curbs do not require maintenance; however, it is advised
to periodically check the spikes to see if they have come up. If they have,
make sure to keep them hammered down below the surface of the parking
curb.