Use and Care Manual

Installaon Steps
Step 1 — Measure Wall
Measure the distance between the ceiling or top
plate and the oor. Subtract 1/8” - 1/4” from the
measured length.
Step 2a — Measure & Cut MLV
Roll out the Mass Loaded Vinyl and measure out
the length you need to cut for the secon you’re
applying.
Step 2b:
Using a T-Square or Straight Edge,
prepare to make a clean, straight
cut with a ulity knife at the desired
length.
1
Required
Tools & Supplies
• Mass Loaded Vinyl
• Tape Measure
• Ulity Knife
• T-Square or Straight Edge
• Drill or Impact Driver
• Drywall Screws & Washers
• or Cap Nails
• Seam Tape
• Acouscal Sealant
• Caulk Gun
TECHNOFLEX INTERNATIONAL
Email: [e-mail] | Telephone: [phone]
technoflexintl.com