Operation Manual

3
12
8. MAX/MIN key
- Press it to check the minimum and maximum
temperature records.
9. PROJECTOR
- Project the time and indoor/outdoor temperature
(automatically switch between indoor and outdoor
temperature in every 5 seconds. )
10. REVERSE key
- Press it to reverse the projected date.
11. FOCUS knob
- Adjust the quality of the projected date.
12. DC JACK
- To power the unit.
13. RECEIVE key
- Press it to receive the RC signal for reception testing.
14. °C/°F key
- Press it to switch between Celsius and Fahrenheit.
15. NIGHT LIGHT FUNCTION ON/OFF switch
- Slide it to turn on/off the night light function.
16. NIGHT LIGHT SENSOR
- Turn on the function, the night light will turn on
automatically in dark environment.
VIEWING THE CHANNEL
The default channel is Channel 1. In normal time mode,
press “UP” key to view the channels from 1 to 3. Besides,
the channels can automatically switch by pressing and hold-
ing the “UP” key for 2 seconds, with “beep” tone.
USING THE PROJECTOR
Press the SNOOZE/LIGHT key to turn the projector on, ro-
tate the projector to project the light beam to a dark back-
ground within 1-4 meters, the projected data will be dis-
played on the dark background as following diagram.
Note:
1. Press the SNOOZE/LIGHT key once, back light and
the projection last for 5 seconds, then press the
“ ” key will reverse the projected data.
2. If using DC power, the projected data will be always
on.
3. The rotate angle of the projector is ±90º.
4. Adjust the quality of the projected data by adjusting the
FOCUS knob.