RADIO CONTROLLED PROJECTOR CLOCK User’s instructions P17018365A0173200E
POWER Main unit: 4.5V, use 3 x AA 1.5V Remote sensor: 3V, use 2 x AA 1.5V The multifunctional clock is equipped with many functions providing thorough information to you. The receiver unit has a clear, easy-to-read display that shows minimum/maximum indoor and outdoor temperature, as well as time and date. It is able to receive and display readings from up to 3 remote sensors.
SPECIFICATION MAIN FEATURES: WEATHER STATION: MAIN UNIT Operating range: -5°C~50°C 23° F~122°F Resolution: 0.1°C/°F (above -10°C/32°F) 1°C/°F (below -10°C/32°F) Radio controlled signal: WWVB/DCF/MSF 10 16 1 13 14 2 REMOTE SENSOR 3 ON OFF Operating range: -20°C~60°C -4°F~140°F Resolution: 1. SNOOZE/LIGHT key: - Turn on the projector and backlight for 5 seconds. - Stop the current alarm when it is sounding and enter into snooze mode. 0.
TEMPERATURE TREND The temperature-trend indicator shows the trends of changes in the forthcoming few minutes. Arrows indicate a rising, steady or falling trend. 4. TIME key: - Press it to switch between Month/Date and alarm time mode. - Press and hold it for 2 seconds to enter normal time setting. - In normal time setting, press it to step the setting items.
8. MAX/MIN key - Press it to check the minimum and maximum temperature records. 9. PROJECTOR - Project the time and indoor/outdoor temperature (automatically switch between indoor and outdoor temperature in every 5 seconds. ) 10. REVERSE key - Press it to reverse the projected date. 11. FOCUS knob - Adjust the quality of the projected date. VIEWING THE CHANNEL The default channel is Channel 1. In normal time mode, press “UP” key to view the channels from 1 to 3.
NOTE: 1. 2. 3. If no signals are received or the transmission is interfered, “—” will appear on the LCD. Relocated the clock or transmitter in other positions and make sure the transmission is within the effective range of 80m approx. After several trails in vain, please reset the clock thoroughly. Try out where your multifunctional alarm clock receives the signals best. CHECKING AND DELETING MAX/MIN TEMPERATURE RECORDS 17. RESET key - Press it to reset all values to default values.
5. BATTERY DOOR 6. WALL-MOUNTING HOLDER: - Use it to support the transmitter on the wall. 3. 7. TABLE STAND: - Use it to stand the transmitter on the desktop. BEFORE USING THE TRANSMITTER 1. 2. 3. Remove the battery door. Insert 2 x AA size batteries into the battery compartment. Make sure you insert them the right way according to the polarity information marked on the battery compartment. Replace the battery door. NOTE: 1. 2. 3. NOTE: 1. 2.
5. Press “TIME” key to save and exit the setting or let it exit automatically 30 seconds later without pressing any key. ALARM AND SNOOZE SETTING 1. 2. 3. 4. 5. In normal time mode, press “TIME” key to select the ALM1 or ALM2. In ALM1/ALM2 mode, press and hold “ALARM” key for 2 seconds until alarm Hour digit flashes. Press “UP” or “DOWN” key to change the value.
SIGNAL STRENGTH INDICATOR MANUAL TIME SETTING The signal indicator displays signal strength in 4 levels. Wave segment flashing means time signals are being received. The signal quality could be classified into four types: If you are out of the reach of the Radio Controlled Transmitter or if the reception is not reachable, the time can be set manually. As soon as the transmitter is received again, the clock will automatically synchronize with received time.
