Instructions

EN5
Please note:
` If there is no valid operation within 20 seconds, the clock automatically returns to the normal time
mode.
Alarm setting
` Push the “AL” switch to the "on" position, the LCD displays the “ ” icon. At the same time
issued BI-BI sound (Except for RC), the alarm function is ON. Push the “AL” switch to the "off"
position, the “ ” icon will disappears from the display, the alarm function is OFF.
` Press the “mode” button once and the LCD displays alarm time. Press and hold the “mode” button
for 2 seconds until hour of the alarm time starts to flash. Press the “+” and “-” buttons to set the hour.
` Press the “mode” button to confirm your setting, The Minute of the Alarm time starts to flash. Press
the “+” and “-” buttons to set the minute.
` Press the “mode” button to confirm your setting, the snooze time starts to flash. Press the “+” and
“-” buttons to set the snooze duration from 1-60 minutes.
` Press the “mode” button to confirm your setting and to end the setting procedure.
Please note:
` If there is no valid operation within 20 seconds, the clock automatically returns to the normal time
mode.
` The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case
the alarm will be repeated automatically after 24 hours.
` Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst the alarm
signal is heard.
Switching off the alarm signal
` When the alarm is ringing, press any button except the “Light/snooze” button to stop the alarm
signal. It is not necessary to reactivate the alarm. It will ring again this time next day.
Snooze function
` When the alarm is ringing, touch the “Light/snooze” button the alarm mode will to get to SNOOZE
mode. The alarm signal sounds again after the set snooze durati
on.
RF Transmission Procedure
` The weather station automatically starts receiving transmission from outdoor thermo sensor for
outdoor temperature & humidity after batteries inserted.
` The remote sensor will automatically transmit temperature and humidity signal to the weather
station after batteries inserted.
` If the weather station failed to receive transmission from outdoor sensor (“- -.-”display on the LCD),
press and hold the “CH” button for 3 seconds to receive transmission manually. RF icon flashes on
the LCD᧨The weather station starts to receive the remote sensor.
` If the weather station receives 2 or 3 transmitters signals, press the “CH” button to select CH2, CH3
data or cyclic display. The channel switch on the back of the transmitter must be set to a number
that fits the desired channel.