User manual

Turn on or off the alarm
Single press the SET/RESET button during normal time display to turn on or off the alarm.
When the alarm function is turned on the icon appears on the display on top of the time
digits.
Snooze function
When time reaches the set alarm time, the station will give a beep sound to wake you up. The
icon will flash.
1. Press the SNOOZE/CH/REGISTER button once to stop the alarm temporarily, the snooze
icon Zz keeps flashing. The alarm will beep again after snooze duration of 6 minutes.
2. To stop the alarm, press any button except the SNOOZE/CH/REGISTER button when
alarm is beeping. The snooze icon Zz disappears. The alarm will beep again same time
next day.
Note: Alarm duration is approximately 2 minutes.
TEMPERATURE DISPLAYS
The INDOOR temperature displays the temperature of the location of the temperature station.
The OUTDOOR temperature displays the temperature of the location of the outdoor
temperature sensors (outdoor area or another indoor rooms p.e. cellar, loft, etc.).
Outdoor transmitter reception and signal indicator
After the station is powered up, it starts to search for outdoor transmitter signal. The icon
flashes. To start the reception of outdoor transmitter signal manually, press and hold the
SNOOZE/CH/REGISTER button for 2 seconds.
Receiving signal ( icon flashing)
Successful reception ( icon becomes static)
Failed reception ( icon disappear)
Press the SNOOZE/CH/REGISTER button once to display continually the temperature of only
one outdoor sensor (1 channel).
Press the SNOOZE/CH/REGISTER button repeatedly to display sequentially the temperatures
of all outdoor sensors (channel 1, 2 and 3).
Press the SNOOZE/CH/REGISTER button repeatedly until the icon is shown. The
temperature display will switch automatically between all 3 outdoor sensor channels (channel
1, 2 and 3). Press the SNOOZE/CH/REGISTER button to cancel.
°C/°F Display
Press and hold the SELECT button for 2 seconds, the temperature display format °C/°F
flashes. Press the SET/RESET button to select the °C (Celsius) or °F (Fahrenhei t)
temperature display format. Press the SELECT button again to store the setting.