Operation Manual

24
HOW TO INSTALL AND REPLACE BATTERIES IN THE WEATHER
STATION
The Weather Station uses 2 x AA, IEC LR6, 1.5V batteries. When
batteries need to be replaced, the low
battery icon will appear on the LCD. To
install and replace the batteries, please
follow the steps below:
1. Lift up the battery compartment
cover.
2. Insert batteries observing the
correct polarity (see marking).
3. Replace compartment cover.
HOW TO INSTALL AND REPLACE BATTERIES IN THE
TEMPERATURE TRANSMITTER
The Temperature Transmitter uses 2 x AAA, IEC LR3, 1.5V battery. To
install and replace the batteries, please follow the steps below:
1. Remove the battery compartment cover at the
back of the transmitter.
2. Insert the batteries, observing the correct polarity
(see marking).
3. Replace the battery compartment cover on the
unit.
Note:
In the event of changing batteries in any of the units, all units need to be
reset by following the setting up procedures. This is because a security
code is assigned by the transmitter at start-up and this code must be
received and stored by the Weather station in the first 3 minutes of
power being supplied to it.