Operation Manual

POSITIONING THE MOONPHASE WALL CLOCK:

There are two possible ways to mount the Moonphase wall clock:

• use of the foldout table stand, or

• wall mounting

FOLDOUT TABLE STAND

The foldout table stand leg is located on the backside. Pull the stand out

from the bottom center edge of the Moonphase wall clock, below the battery

compartment. Once the foldout table stand is extended, place the

Moonphase wall clock in an appropriate location.

WALL MOUNTING

1) Using a straightedge, horizontally space at 70 mm three screw positions

on a wall.

2) Install three mounting screws (not included) into a wall within

transmission range—leaving approximately 5mm extended from the

wall.

3) Place the Moonphase wall clock onto the screws, using the hanging

holes on the backside. Gently pull the Moonphase wall clock down to

lock the screws into place.

Note:

Always ensure that the Moonphase wall clock locks onto the screws before

releasing.

POSITIONING THE OUTDOOR TEMPERATURE TRANSMITTER

The Outdoor Transmitter is supplied with a holder that may be

attached to a wall with the three screws supplied. Before securing the

transmitter, ensure that the 433MHz signal is properly received. To

attach to the wall, please follow the steps below:

1. Mark the wall using a pen through the holes in the holder to

obtain the exact drilling position.

2. Drill holes in the wall at the points marked.

3. Screw holder onto wall.