Operation Manual

Hour flashing
Minutes flashing
1. The hour digit will start flashing.
2. Use the OUT/+ key to set the hour.
3. Press again the SET key to set the minutes. The minute digits start
flashing.
4. Use the OUT/+ key to set the minutes.
5. Confirm with the SET key and enter the Calendar setting.
Note:
The unit will still try and receive the signal every hour despite it being
manually set. When it does receive the signal, it will change the manually
set time into the received time. During reception attempts the DCF tower
icon will flash. If reception has been unsuccessful, then the DCF tower
icon will not appear but reception will still be attempted the following hour.
CALENDAR SETTING:
Year
Date and month (24hr time format)
Month and date (12hr time format)
The date default of the Weather station is 1. 1. in the year 2004. Once the
radio-controlled time signals are received, the date is automatically
updated. However, if the signals are not received, the date can also be set
manually.
1. The year starts flashing.
2. Use the OUT/+ key to set the year (between year 2003-2029).
3. Press the SET key again to confirm and to enter the month setting.
The month starts flashing.
4. Use the OUT/+ key to set the month.
5. Press the SET key again to confirm and to enter the date setting
mode. The date starts flashing.
6. Use the OUT/+ key to set the date.
7. Confirm all calendar settings with the SET key and enter the ºC/ºF
Temperature setting.
°C/°F TEMPERATURE SETTING:
Digit flashing
The temperature display can be selected to show temperature data in °C
or °F (Default °C).
1. Use the OUT/+ key to toggle between “°C” or “°F”.
2. Confirm with the SET key and enter the hPa / inHg setting.
22