User manual

Manual – WS 7060
- EN03 -
values. Outdoor sensors can be placed away from the main station as soon as all channels are receiving
values.
Note:
Should the sensor reception fail after 3 minutes, the reception symbol of the specific channel will disappear.
In this case, restart initial operation with a set of fresh and full batteries until all sensors can be connected.
Temperature alarm setting
- In normal display mode, press the Alert button for 3 seconds to enter alert setting mode
- In alert setting mode, press the + or – button to select an outdoor channel.
- Press the Alert button to confirm the selected channel. The down limit symbol is blinking.
- Press the + or – button to change the value of the down limit.
- Press the Alert button to confirm the alert changes. The up limit symbol is blinking.
- Press the + or – button to change the value of the up limit.
- Press the Alert button to confirm the alert changes. The up&down limit symbol is blinking.
- Press the + or – button to activate the alarm and the alarm symbol is blinking. Press the + or – button
again to deactivate the alarm and alarm symbol is no longer displayed.
- Press the Alert button to confirm the alert changes and exit the alert setting mode.
Note:
- The alarm symbol will be permanently displayed in the corresponding channel as long as the alarm stays
activated.
- Down limit default value is 0 ℃, up limit default value is 35℃.
- In alert setting mode, it will be exit when there is no any operation in 20 seconds
- In alert setting mode, press the + or – button once to change value by 1 unit or hold the + or – button to quicker
adjust the value.
Temperature alarm
- This station has an up limit & down limit for 3 alarms, one for each outdoor channel.
- If temperature reaches a limit, is higher then up limit or below down limit, then the or and the
symbols will flash and the alarm will sound.
- While alarming, press any button to stop the alarm sound, but the symbol will still be flashing. The alarm
sound will also turn off automatically after 1 minute, if no button is pressed.
- The symbol will no longer blink and become permanent again, once the temperature value is no longer at
or beyond the set temperature limit.
Note
- The alarm can permanently be deactivated by using the temperature alearm setting.