User manual

Manual – WS 7060
- EN02 -
Outdoor sensor
A – Sensor number (same as default channel setting) B – Wall mounting hole
C – Channel switch (default set to sensor number) D – Battery cover
E – Battery compartment F – Stand
Initial operation
- Slide the battery cover off the battery compartment of all sensors and the main station.
- Make sure that the set number on the channel switch is the same as sensor number on front of sensor.
- Insert 2 x AAA batteries into the battery compartment of each of the outdoor sensors.
- Insert 2 x AAA batteries into the battery compartment of the main station.
- Slide the battery cover back onto the battery compartments of all outdoor sensors and the main station.
- When fully powered, the display on the main station will show all symbols for 2 seconds and then change into
sensor receiving mode for 3 minutes. Keep the sensors close to the main station until all channels display