Operation Manual

Note:

When the 433MHz signal is received correctly, do not re-open the battery covers of either the transmitter or

Weather Station, as the batteries may spring free from the contacts and force a false reset. Should this

happen accidentally then reset all units (see Setting up above) otherwise transmission problems may occur.

The transmission range is about 25 m from the transmitter to the Weather Station (in open space). However,

this depends on the surrounding environment and interference levels. If no reception is possible despite the

observation of these factors, all system units have to be reset (see Setting up).

POSITIONING THE WEATHER STATION

The Weather Station comes attached with a removable table stand, which provides the

option of table standing or wall mounting the unit. Before wall mounting, please check that

the outdoor temperature can be received from the desired locations. To wall mount:

1. Fix a screw (not supplied) into the desired wall, leaving the head extended out by

about 5mm.

2. Remove the stand from the Weather Station by pulling it away from the base and

hang the station onto the screw. Remember to ensure that it locks into place before

releasing.

POSITIONING THE OUTDOOR TEMPERATURE TRANSMITTER

The Temperature Transmitter is supplied with a holder that may be attached to a wall

with the three screws supplied. Before securing the transmitter, ensure that the

433MHz signal (outdoor temperature readings) is properly received. To attach to the

wall, please follow the steps below:

1. Mark the wall using a pen through the holes in the holder to obtain the exact

drilling position.

2. Drill holes in the wall at the points marked.

3. Screw holder onto wall.