Operation Manual

Note: When 24h mode display is selected, the calendar format will be date and month display.
When 12h mode display is selected, the calendar format will be month and date display.
MANUAL TIME SETTING
In case the Weather Station is not able to detect the DCF-signal (disturbances, transmitting distance, etc.),
the time can be manually set. The clock will then work as a normal Quartz clock.
To set the clock:
1. The hour and minutes digits start flashing in the time display section.
2. Use the IN key to adjust the hours and the OUT key to adjust the minutes. If you hold the key while
you adjust, the hours move 1 hour and the minutes move 5 minutes.
3. Confirm with the SET key and enter the “Calendar Setting” or exit the setting mode by pressing the
CH key
Note:
The unit will still try to receive the signal at each full hour despite it being manually set. When it does receive
the signal, it will change the manually set time into the received time. During reception attempts the DCF
tower icon will flash. If reception has been unsuccessful, then the DCF tower icon will not appear but
reception will still be attempted the following hour.
CALENDAR SETTING:
Date (flashing) Month (flashing) Year (flashing)
Minutes (flashing)
Hours (flashing)
35