User manual
• Press “MODE” to switch from time display to A1 display
• Press and hold the key “MODE” for 3 seconds ,the flashing alarm time are shown
• The hour display of the alarm time is flashing. Use “+“ und “-“ to select the hour.
• Press “MODE” to confirm.
• The minute display of the alarm time is flashing. Use “+“ und “-“ to select the minute.
• Press “MODE” to confirm.
• Then press “MODE” to switch from A1 display to A2 display
• The same setting as for A1.
Daily alarm on/off
• When showing A1 alarm time, press “-“ to activate the alarm 1 with alarm symbol showing.
• Press “MODE” again cancel the alarm
• When showing A2 alarm time, press “-“ to activate the alarm 2 with alarm symbol showing.
• Press “MODE” again cancel the alarm
• A1 for alarm from Monday to Friday, A2 for alarm from Saturday to Sunday.
Information:
• The clock automatically changes from set-up mode to time mode if no keys are pressed for
20 seconds.
• The alarm sounds for 2 minutes if no key is pressed to stop it.
Snooze function
To activate the snooze function, follow the steps below
• Press the key “SNOOZE/LIGHT“, while the alarm sounds, to activate the snooze function.
• If the snooze function is activated, alarm symbol is flashing.
• The alarm repeat after 5 minutes.
• The snooze function can be stopped by pressing any key.
12/24 hours mode
The time display can be in 12 AM/PMor 24 hours mode.
°C/°F temperature display
The temperature display can be in °C or °F. Press t he key “-“ to switch between the mode.
Max./ Min. for the indoor/outdoor temperature and humidity
Press “+” for displaying of indoor/outdoor max./min. of temperature and humidity.
Temperature alert set-up
• Press “Channel” to select the channel (CH1, CH2, CH3) if more than one outdoor sensor
are within reach.
• Press and hold the key “-” in the area of outdoor , select ON/OF when flashing.
• Press “MODE” , the upper limit temperature is flashing, use “+” , “-“ to set the maximum alert
temperature.
• Press “MODE “, the lower limit temperature is flashing, use “+” , “-“ to set the minimum alert
temperature.