Operation Manual

Once the sensor is powered up, press and hold the PLUS(+)

key for approx. 2 seconds in the normal display mode, the

base station will sound a short beep and synchronize to the

sensor otherwise no weather data will be received.

Battery change only in the base station:

1. Connect power adaptor to base station and power outlet.

2. Open the battery cover located at the back of the base

station.

3. Remove the old batteries, insert with new ones of the

recommended type and replace the cover

This method of battery replacement will result in no loss of

MIN/MAX and history data. However in case of possible

power failure, the base station will lose the MIX/MAX and all

weather data recordings and will need to be synchronized to

the sensors again by pressing the PLUS(+) key for 2 seconds.

Note:

When batteries require replacement for the base station, the

low battery indicator will light up on the LCD.

Please participate in the preservation of the

environment by properly disposing of all used-

up batteries and accumulators at designated

disposal points. Never dispose of batteries in

a fire as this may cause explosion, risk of fire

or leakage of dangerous chemicals and fumes

19. Interferences and problems with operation

Problem & cause Remedy

Distance between

transmitters and

receiver too long.

Reduce distance between

transmitters and receiver to

receive signal