Operation Manual

10. Resetting & factory settings:

As previously mentioned, in the event of a power reset to the

sensor (for example a change of batteries), the base station

has to synchronize to the sensor again otherwise no weather

data will be received. To do this, simply press and hold the

PLUS(+) key for 2 seconds and a short beep will sound to

synchronize the base station to the sensor. When the units

are synchronized, the data will be received again and the

base station will return to normal operation mode.

Do not reset the power of the base station otherwise all 175

sets of recorded weather history data for transferring to the

PC will be lost (for full details of PC use, please see PC user

manual in the enclosed Heavy Weather CD-ROM).

However if you wish to make a full reset of the base station

and return to the original factory settings, simultaneously

press and hold the PRESSURE and WIND keys for about 5

seconds. The base station will beep once and the entire LCD

will light up for 5 seconds and go back to the original factory

settings. This process with clear all previous user defined

values and all weather history recordings.

Factory default settings:

The following table shows the factory default values of the

weather station:

Matter: Default Setting:

Time 0:00

Date 01.01.2001

Time zone 0

Alarm time 0:00

Relative air pressure 1013.0 hPa

Weather-picture

threshold

3 hPa

LCD contrast level 5 (1-8 levels)

Rainfall per impulse 0.518mm

Storm alarm 5 hPa

Relative air pressure

alarm

960.0 hPa

(low)

1040.0 hPa

(high)

Indoor tem

erature 10.0ºC (low) 30.0ºC (high)