Operation Manual

limited to hurricane, typhoon, and cyclones seasons. Do not place the unit in
area of high winds.
3. Do not place the remote temperature sensor more than 30 meters (98 feet) from
the receiving weather station. The remote temperature sensor is most effective if
there are no obstruction and interference between the remote temperature
sensor and the weather station. The remote temperature sensor might have to
closer than 30 meters if the weather station is not able to receive any signals.
This is due to obstructions and interference. The user might need to experiment
with various locations to get the best reception.
4. If there is a change in power source for the main unit (i.e. from batteries to DC or
vice versa), press «RESET» button(RTS3) on the remote temperature sensors to
reconfigure remote temperature sensors. See figure 5.
Configuring Weather Station to receive remote temperature signals.
1. Follow the above instructions to set up remote temperature sensor.
2. Press “▲ CHANNEL” button (3) on weather station for 3 seconds. will flash.
This will reset all temperature memories.
3. The weather station will begin scanning for signals for channel 1. As soon as
signals are received for channel 1, the temperature will be displayed. The
weather station will automatically scans for the other channels. It will scan each
channel for approximately 3 seconds before skipping to the next channel.
4. Once all your channels are received press “
▲ CHANNEL”
button (3) once to
confirm the channel.
5. The weather station will receive a new signal automatically every 30 seconds to
update the remote temperature.
6. Press “▲ CHANNEL” button (3) on weather station repeatedly to toggle between
channel 1, channel 2, and channel 3.
7. will be displayed if any of the remote temperature sensor’s battery needs
replacing.
Temperature & humidity memory
1. Press “Max / Min” button (2) to display maximum recorded temperature,
minimum recorded temperature, and current temperature. “max” indicates maximum
temperature. “min” indicates minimum temperature.
2. Press “Max / Min” button (2) again to display current temperature and humidity.
Celsius / Fahrenheit
1. Press “▼/°C/°F / RCC” button (4) to toggle between displayi ng the temperature
in Celsius and Fahrenheit.
Warnings
• Do not subject the unit to excessive force, shock, dust, temperature or humidity.
• Do not immerse the unit in water.
• Dispose the complete unit when battery is no longer charging or when the unit is
no longer displaying the temperature and / or humidity.
• Do not remove any screws.
• Do not dispose this unit in a fire. IT MAY EXPLODE.