Operation Manual

30
a) product shows obvious signs of damage. b) product does not function. c) product has been stored in unfavorable conditions for a long period of time. d) heavy strain during product’s transport may have occurred.
INSERTING AND REPLACING BATTERIES IN THE RECEIVER Low power batteries usually reduces the contrast of the LCD of the remote cost control receiver. If the LCD of
the receiver becomes difficult to read then the batteries must be replaced immediately. The receiver uses two
AAA, LR3 Batteries, 1.5V, which has an estimated average lifetime of 2 years.
To replace the batteries, simply follow these steps: 1. Slide the battery cover downwards and remove. (Figure 3) 2. Remove old batteries and replace with new batteries of the same size and voltage whilst observing
correct polarity.
3. Replace battery cover and secure back into place.
Please participate in the preservation of the environment and return all used batteries to an authorized depot.
Figure 3
Battery cover
Battery compartment
Back of the receiver