Operation Manual

39
4. After learning reception is over the LCD shows “NO NEW DEVICE” in case no new device was found.
(Figure 18)
5. If a new device is found, the LCD shows the ID of the Power Monitor on the upper line and SCAn on the
lower line. (Figure 19)
6. Press the LRN/SCAN key to confirm this Power Monitor as CH1. Or, press CH / + key to select the
channel number, which should be assigned to this power monitor and then press the LRN/SCAN key for confirmation. After the right channel number is found, this Power Monitor can be learned instantly by pressing the LRN/SCAN key.
7. If you don’t want to select the detected Power Monitor you can press the RESET key for ignoring that
Power Monitor.
Figure 18 Figure 19