Operation Manual

SETTING UP:

1. Plug the Power Monitor(s) into the AC line. About 3 seconds later, the LED indicator of the Power

Monitor will light on for 2 seconds. Its means that the power monitor works normally. If not, unplug the

power monitor and wait for 2 minutes. Afterwards, repeat this procedure. Performs the reset function in

the power monitor again.

2. Insert battery into the receiver, an icon “NO DEVICE” with “----“ will be shown. (Figure 16) If not, remove

battery and wait for 2 minutes and then repeat this procedure. If there is already a device learned in one

of the channels, you can clear the channel by pressing RESET – CH – RESET.

3. To start the operation, it is required to connect the Remote Cost Control Receiver and the power monitor.

Press LRN/SCAN key of receiver for a long time (around 2 seconds) to start the 6 seconds reception

with learning of new channels. LCD shows “LRN” and “SCAn” during the learning process. (Figure 17)

Figure 16

Figure 17