Operation Manual

37
2. Press CH / + key to modify the blinking digit. 3. Press TARIFF key to go the next digit. 4. After setting the least significant figure, press TARIFF key again to exit the tariff mode. If exiting the
setting mode by timeout, the new set tariff value will not be updated and the old tariff is still be used.
IMPORTANT!
If the displayed information on the receiver does not be updated or is remain unchanged for a
long time, it means that the sending data from the power monitor is overflow. User needs to reset the Power Monitor (by pressing and holding its 4 seconds). The power monitor will send the overflow data when it is
operated continually for around 2 years after the reset function is performed.
THE POWER MONITOR The LED indicator also performed as a “reset” function for the power monitor. LED indicator • Will light on for 2 seconds when the power monitor is started up (just plug into the AC line).
• Will flash for every transmission (around 5 seconds).
When performing reset function: • Press and hold the button for about 4 seconds will reset all the information to zero, except the
instantaneous (W) and maximum power (MAX W). During the process, the LED button flashes 3 times and then lights up to indicate the Power Monitor has been reset. When the user releases the button, the LED light turns off.