Full Product Manual

Technical Parameter
Product Type
Height
(mm)
Welding
Distance
(mm)
Thickness
(mm)
Tensile Strength
of Welding
Points (N/cm)
Tensile Strength of
Commection of
Cells (N/cm)
Tensile Strength of
Yield of Each
Sheet (Mpa)
Textured and
Perforated 50 330 1.0~1.5
≥100 ≥120 ≥20
Textured and
Perforated 100 330 1.0~1.5
≥100 ≥120 ≥20
Textured and
Perforated 200 330 1.0~1.5
≥100 ≥120 ≥20
Remarks:
This is a basic technical specification.
All the above technical parameters can be reached according to the customer's requirement and other special standards can
be carried out by agreement or contract.
Installation
How to Install Geocell
(a) Planning of Installation
It is advised that adequate planning and design of the installation be undertaken before the commencement of site
work. When planning the installation, attention should be given to ensuring that all equipment and tools required for
installation are available. In addition, sufficient personnel (with the necessary skills) should be employed on the
installation work.
(b) Site Preparation
Geocells perform better when installed on even, well-prepared surfaces. Before installing geocell, it is advised that
the slope surface is made level and even. Any sharp objects and stones that are much larger than (or significantly
different in shape and angularity from) the intended fill material (i.e material to be placed in the cells) should be
removed. If necessary, to achieve a level surface, compaction of the slope surface should be undertaken. If
required, a suitable geotextile may be used as a separator between the geocell and the slope surface.
(c ) Expanding the Cells, Fixing, and Anchoring geocell is supplied flat in panel form. On-site it must be expanded
and tailored to the desired dimensions and shapes. geocell is flexible enough to go around trees or other structures
on the installation surface and some variations in cell shapes and sizes may be necessary when installing the