User Manual

2-10
2.14.1 Windows Program Requirements:
1. PC compatible computer running Windows 95/98/NT/2000/ME. CD ROM drive and an
available serial port.
2. Bench power supply of 28 volts DC.
3. PIB-100 Programming Interface Box (p/n 001108-1) - use cables that are provided with the
PIB-100 programming interface box. Do not use cable p/n 943165-4 which is shown in Figure
2-2 and is for use with the DOS program only.
2.14.2 Windows Program Installation:
1. Insert the CD into the drive.
2. Open the CD with windows explorer.
3. Open the MultiTDP directory and double click the MultiTDP_Install.exe file.
4. Follow on screen instructions.
2.14.3 Connections:
1. Follow the connection instructions supplied with the PIB-100.
2. Do not turn on the 28 volt power supply until all connections have been made.
2.14.4 Running the Windows Program:
1. On the computer, click the Start menu button.
2. Select Programs from the Start menu.
1. Select Technisonic from the Programs menu.
2. Select
MultiTDP
.
3. The program will start. The MultiTDP program is used for almost all of Technisonic’s
transceivers, therefore it has to be set up specifically for your TFM-138B.
4. Pull down the
File
menu and click
Select Radio
.
5. Click the
TFM-30/138/138B/403
line.
6. The display will configure itself for the PIB-100. Click the dot beneath TFM-138B.
7. Pull down the Com Port menu and select the com port that you have connected the PIB-100.
8. The software is now ready to use. To get a full instruction manual, pull down the Help menu
and select Documentation in PDF format.