User's Manual

08RE399 TDFM-136B Operating Instructions
3.1 Operator Level 1 Commands
This section lists the commands available to the user in Level 1. The availability of the
commands is subject to the restrictions set by the Permissions policy (see section 2.5).
The commands are listed by increasing number.
3.1.1 Select the Operating Memory for the Main Channel
Level 1 Key Scope: Main only
This command allows you to directly select the memory for the MAIN channel operation, the cursor
will appear at the first digit in the channel number as shown:
Figure 3-1. The User Screen to Enter a Memory Number
Now, select a number from 001 to 230, the cursor wraps. Valid edit keys are:
to
Enter digit, cursor automatically advances and wraps
accept the entry and continue
abandon the entry and exit
Note: If the channel number selected is out of range then the cursor will remain until the user
enters a valid number. If there is no information programmed for the channel, the editor will
return to the previously displayed channel.
3.1.2 Increase Display Brightness
Level 1 Key Scope: Main and Guard
Press and hold the up arrow (2) key to increase the brightness of the LED character display, it
stops when the key is released or at maximum, whichever occurs first.
3.1.3 Edit Channel Operating Mode
Level 1 Key Scope: Main and Guard
This command will edit the Operating Mode of the selected channel. Upon selecting this command
the cursor will appear at the MODE position.
Figure 3-2. The User Screen to Edit the Operating Mode
28 Technisonic Industries Ltd
B
!)*$%&'

,3E!"#$%&'