User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-136A Operating Instructions Page 2-26
TiL 09RE405
L4-2 Unused
L4-3 Set Command Permissions
This command allows those responsible for setting policy to select which commands in the
command set will be accessible in the Command/Operator Levels (levels 1, 2, and 3). All the
commands in those three levels are affected EXCEPT: ‘PROG’ (0) and ‘ESC’ (*).
The factory default configuration has all the commands enabled, except L2-2 and L2-8. Figures 2-
34,2-35 and 2-36 are factory default positions.
The Set Permissions screen shows the level being affected (L1, L2, or L3), followed by the
command number, and an optional 'g' indicating Guard channel operation for that command (if
applicable). The character directly under each number (or associated 'g') indicates whether or not
the command may be accessed. The character is a solid round dot if the command is to be
accessible (enabled). The character is an empty dot or donut if the command is to be restricted
(disabled).
To access the command permissions.
The ‘Set Permissions’ for command level 1,2 and 3 screens appear below:
L 1 : 1 2 3 g 4 5 6 7 g 8 9 g
• • • • • • • • • • • •
FIGURE 2-34 User Screen to Edit the Level 1 Permissions
L 2 : 1 g 2 3 5 6 g 7 8 9 g
• • o • • • • • o • •
FIGURE 2-35 User Screen to Edit the Level 2 Permissions
L 3 : 1 2 3 4 5 6 7 8 9
• • • • • • • • •
FIGURE 2-36 User Screen to Edit the Level 3 Permissions
The user may edit these permissions as follows:
toggle the permission (• =enabled, o= disabled)
step up/down through command levels
move cursor forward / backward through commands
accept the entry and return
abandon the entry and exit