User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-136A Operating Instructions Page 2-21
TiL 09RE405
L3-5.4 Setting the Delay Timer Range: 0-15s, Default: 5 seconds
The Delay time is the time that the radio will remain monitoring a channel after receiving on that
channel has ended. If the timer is set to zero (0), then the unit will resume scanning immediately
after the receive activity ends. This is the timer that affects the Revert Mode 'Contacted'.
3 - 5 E d i t S c a n P a r a m e t e r s
D e l a y T i m e r : 0 5
FIGURE 2-26 User Screen to Set the Scan Delay Timer Value
The user can set the Scan Delay Timer value as follows:
to to decimal mode: enter number, cursor automatically advances
advance to next screen
abandon the entry and exit
L3-6 Configure the PTT Timer
The PTT time will run whenever the user holds PTT. The PTT timer duration may be set using
this command: scroll through the available selections: OFF, 30 seconds, 60 seconds and 90
seconds.
3 - 6 S e t P T T T i m e r
T i m e r S e t : 9 0 s e c
FIGURE 2-27 User Screen to Set the PTT Timer Value
The user can set the PTT Timer value as follows:
to step up through available timer values
step down through available
advance to next screen
abandon the entry and exit