User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-136A Operating Instructions Page 2-19
TiL 09RE405
L3-4 Display Software Release and Version Information
This command allows the user to see the current software release and version number for both
the Main code, and the Boot loader code. This information is displayed on the bottom row as
follows:
0 0 1 M a i n D 1 3 6 . 0 0 0 0 R n
M a i n C o d e 2 . 0 . 0
FIGURE 2-22 User Screen Showing the Code Release Information
The user may select which information is displayed as follows:
toggle the Main/boot loader code version display
exit
The number format is as follows: Release. Version. Revision
So the number: 2.0.0 reads as Release 2, Version 0, Revision 0
Release refers to the fundamental software architecture (i.e. big things)
Version refers to the feature set operating within this architecture
Revision refers to bug fixes and minor updates
L3-5 Edit Scan Parameters (MN)
This command allows the user to edit the parameters that govern the SCAN operation. There are
4 (four) parameters that may be configured: Revert Mode, Reply Timer, Monitor Timer, and Delay
Timer. As with the Create/Edit All command (L2-1), this command is sequential, allowing the user
to move between parameters using the enter key, at the last parameter, this key accepts all and
exits.
L3-5.1 Setting the Revert Mode default: last contacted
The Revert Mode refers to whether the radio will, when keyed, transmit on the selected memory
channel, or on the last contacted memory channel. The radio will only respond on the last
contacted channel for a time determined by the Delay timer setting, once the Timer times out, the
unit will then always transmit on the selected channel.
3 - 5 E d i t S c a n P a r a m e t e r s
R e v e r t M o d e : C o n n e c t e d
FIGURE 2-23 User Screen to Select the Scan Revert Mode
The user can select the REVERT mode as follows:
toggle the revert mode
advance to next screen
abandon the entry and exit