User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-136A Operating Instructions Page 2-18
TiL 09RE405
2.4 COMMAND/OPERATOR LEVEL 3
The Command/Operator Level 3 commands are configuration commands that allow the operator
to configure many of the default parameters of the radio, in addition, level 3 has the PC upload
and download commands.
L3-1 Select Boot Channel
This command allows the user to select which method will be used to determine the memory that
will be used for the Main Channel when the unit is turned on.
The available choices are: the last Selected channel or the last Programmed channel.
The default is: last Selected channel.
3 - 1 S e t B o o t M e m o r y
B o o t O n : L a s t S e l e c t e d
FIGURE 2-20 User Screen to Select Main Channel Boot Mode
The user may select the boot memory for the main channel as follows:
toggle the boot mode
accept the entry and return
abandon the entry and exit
L3-2 Unused
L3-3 Select Hex/Decimal Edit Mode
This command allows the user to select whether to edit the TalkGroup and the NAC numbers as
Hexadecimal (Hex) or as Decimal numbers. The other parameters are edited in decimal only.
The default is: Hex Edit Mode (HEX is indicted by a preceding dollar sign: $)
3 - 3 S e t H e x / D e c i m a l E d i t
E d i t i n : H e x
FIGURE 2-21 User Screen to Select the Numeric Edit Mode
The user may select the TalkGroup and NAC Edit mode as follows:
toggle the Hex/Decimal edit mode
accept the entry and return
abandon the entry and exit