User's Manual

TECHNISONIC INDUSTRIES LIMITED

www.til.ca

TDFM-136A Operating Instructions Page 2-14

TiL 09RE405

L2-5 Edit Scan List & Enable/Disable Scan (MN)

This command allows the user to select which of the SCAN LISTs (if any) that the selected

channel is included in. The memory must be a member of one of the fifteen (15) scan lists that

are supported. In addition, it allows the user to select whether or not the scan is enabled for the

current memory.

The cursor will move to the fourth (4th) position on the top line, the default scan list is shown in

subscript. If a bar is over the top of the character, this indicates that scan is disabled for this

memory. If there is no bar, then scan has been enabled.

0 1 5

D e s c w 1 4 1 . 0 0 0 0 R x

E d i t Z o n e / S c a n ( ↑ ↓ 0 , # * )

FIGURE 2-14 User Screen to Enter a Scan List or Enable/Disable Scan

The user may select the scan zone for the memory as follows:

step up through available scan lists

step down through available scan lists

toggle the scan enable / disabled (bar = disabled)

accept the entry and return

abandon the entry and exit

Note: If a scan list is full, it will NOT appear in the list. This includes the default list, if this

happens, the unit will display the next higher available list, this will stop at list 15 and

then loop back to list 1.

0 1 5

D e s c w 1 4 1 . 0 0 0 0 R x

G D 2

G u a r d 2 w 1 7 4 . 0 0 0 0 R t

FIGURE 2-15 User Screen Showing Scan Disabled for this Memory

L2-6 Edit Channel Text Description (MN/GD)

This command allows the user to edit the text description for the selected channel. There are four

groups of characters that may be used; upper case (A-Z), lower case (a-z), numbers (0-9), and

16 extra characters (shown in table 2-6 below). The user can change character groups at any

time and as many times as desired during a description edit session.

0 0 6

D e s c w 1 4 1 . 0 0 0 0 R x

E d i t T e x t ( ↑ ↓ ← ← 0 , # * ) A Z

FIGURE 2-16 User Screen to Edit the Text Description