User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-136A Operating Instructions Page 2-11
TiL 09RE405
L1-9.6 Edit Project 25 ID Call Value
Scope: digital only, transmit only, range 0-9,999,999
If the P25 ID Call was chosen, the prompt line will display the current ID Call value. This
parameter may only be edited in decimal, as follows:
0 0 1 M a i n D 1 3 6 . 0 0 0 0 T
i
P 2 5 C a l l U n i t # : 0 0 0 0 0 0 1
FIGURE 2-13 User Screen to Edit the P25 ID Call Value
This transmit-only mode allows the user to try to contact a specific radio by transmitting that
radio's user ID. If no radio has that ID then this will fail.
The keys used to edit the ID call parameter are:
to decimal mode: enter number, cursor automatically advances
accept the entry and return
abandon the entry and exit
L1-0 Command Level Up
This key selects the next HIGHER Command Level. The Command Level is indicated by a
subscript digit in the 4th character position on the lower row of the display. See table 2-1.
Upon pressing this key, the radio will remain in the new Command Level for 5 seconds, if there is
no further user input within this time then the radio will revert to Level 1. The Direct Command
Level (level 1) is the normal operating mode for the radio and is indicated by a blank space.
L1-# Not Used
L1-* Not Used