User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-136A Operating Instructions Page 2-7
TiL 09RE405
L1-6 Scroll Forward through Available Memories (MN)
This command will scroll FORWARD, or up, through the programmed channels, scroll speed will
increase as the button is held and the scroll will wrap around and restart from the bottom. Once
the user releases the button the displayed characteristics will be programmed.
L1-7 Edit Channel Operating Frequency (MN/GD)
This command allows the user to edit the Operating Frequency of the selected channel. The
frequency will be edited in duplex mode: first Receive, then Transmit. Once the receive parameter
is entered, the 2nd last character in the display will switch from “R” to “T”, the user can now enter
the transmit value. Note that the receive value is automatically entered, so to get simplex
operation, simply accept this entry. The edit screen appears as follows:
0 0 1 M a i n D 1
3 6 . 0 0 0 0 R g
E d i
t
F r e q u e n c y ( 0 - 9 , # * )
FIGURE 2-6 User Screen to edit the frequency
Upon start, the cursor appears at the second character in the Frequency field of the channel to be
edited. The user may now enter the desired operating frequency as follows:
to decimal mode: enter number, cursor automatically advances
accept the entry and return
abandon the entry and exit
The editor will not accept a value outside the limits of 136.0000 MHz. to 174.0000 MHz. In
addition frequency selection is limited to 2.5 kHz increments in all Operating modes.
L1-8 Decrease Display Brightness
Press and hold the down arrow (8) key to decrease the brightness of the LED display, it stops at
minimum.