User's Manual

TECHNISONIC INDUSTRIES LIMITED

www.til.ca

TDFM-136A Operating Instructions Page 2-6

TiL 09RE405

You may now edit the Operating Mode as follows:

step through the available entries

accept the entry and return

abandon the entry and exit

L1-4 Scroll Backwards through Available Memories

This command will scroll the Main Channel BACK, or down, through the programmed memories

until reaching the lowest memory programmed, it will then wrap around and restart from the top.

Once the user releases the button the displayed characteristics will be programmed. The scroll

speed will increase as the button is held.

L1-5 Start/Stop Scan (MN)

This command allows the user to start and stop Scan operation. The system will scan the

channels that are in the same scan list that the currently displayed Main channel is a member of.

Note that the channels in the scan list must have scan enabled (see command L2-5) to be

scanned. If the memory scan has been enabled then the following screen appears:

0 0 1

M a i n D 1 3 6 . 0 0 0 0 R g

G D 1

G u a r d 1 n 1 5 4 . 0 0 0 0 R t

FIGURE 2-4 User Screen during Scan

Once scan has started the scan list digit flashes to indicate that the unit is in SCAN mode. Also

note that the key level indicator position has the lock symbol

indicating that all keypad keys are

disabled except for:

stop scan

display brightness

Front panel switch operation is modified as well.

Operation of MN/GD or G1/G2 will terminate scan and restore normal operation of keys and

switches. The front panel Squelch button is disabled. The HI/LO power switch is unaffected.

If the user tries to start scan on a channel or memory that doesn't support scan, you will see:

0 0 1 M a i n D 1 3 6 . 0 0 0 0 R g

E r r o r : N O N - S c a n n e d C h a n

FIGURE 2-5 Selecting a Memory/Channel that Doesn't Support Scan