User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-136A Operating Instructions Page 2-5
TiL 09RE405
2.2 COMMAND/OPERATOR LEVEL 1
This section lists the commands available to the user in Level 1. The availability of the commands
is subject to the restrictions set by the Permissions policy (see section 2.5, L4-3). Default level –
no display is shown
L1-1 Select the Operating Memory for the Main Channel (MN)
This command allows the user to select the MAIN channel that the radio is operating on. Upon
selecting this command the cursor will appear at the first digit in the channel number as shown:
0 0 0
E n t e r N u m b e r ( 0 - 9 , # * )
FIGURE 2-2 User Screen to Enter a Memory Number
Now, select a number from 001 to 230 as follows:
to decimal mode: enter number, cursor automatically advances
accept the entry and return
abandon the entry and exit
Note: If the channel number selected is out of range then the cursor will remain until the user
enters a valid number. If there is no information programmed for the channel, the editor
will return to the previously displayed channel.
L1-2 Increase Display Brightness
Press and hold the up arrow (2) key to increase the brightness of the LED display, it stops at
maximum.
L1-3 Edit / Select Channel Operating Mode (MN/GD)
This command will edit the Operating Mode of the selected channel. Upon selecting this
command the cursor will appear at the MODE position. Table 2-3 showing the available
Operating Modes.
TABLE 2-3 Channel Operating Modes
INDICATOR OPERATING MODE
‘w’ Analog Wide (25 kHz)
‘n’ Analog Narrow (12.5 kHz)
‘D’ Digital (12.5 kHz)
0 0 1 M a i n
D 1 3 6 . 0 0 0 0 R g
E d i t M o d e ( ↑ ↓ 3 , # * )
FIGURE 2-3 User Screen Edit / Select Mode with Indicator in Digital Mode
Note: If an Operating Mode is selected that is
incompatible with the current Squelch Mode,
then the Squelch mode will automatically be
changed to one that is acceptable for that
Operating Mode (e.g. ‘x' for analog, 'm' for
Digital Rx and 'g' for Digital Tx).