Installation and Operating Instructions

TECHNISONIC INDUSTRIES LIMITED
T6 Multiband Transceiver Module Operating Instructions
TiL 22RE638 Revision A
6
3.1 GENERAL
The T6 Module is designed to be installed in a Technisonic airborne radio chassis as an option
for extended frequency coverage. These radio chassis include, but are not limited to Technisonic
transceiver models TDFM-9100, TDFM-9200 and TDFM-9300. A TDFM-9100 installation is
shown below. The others are very similar.
The T6 is intended to be mounted in the TDFM 9300/9200 or 9100 chassis and is not visible.
Therefore, a second label must be applied to the outside of the of the TDFM-9X00 that contains
the following text:
For TDFM-9300 “TDFM 9300 Multiband, “Contains Module: FCC ID IMA-T6”
For TDFM-9200 “TDFM 9200 Multiband, “Contains Module: FCC ID IMA-T6”
For TDFM-9100 “TDFM 9100 Multiband, “Contains Module: FCC ID IMA-T6”
In addition, external labelling for Industry Canada shall be applied to the TDFM-9300, TDFM-
9200, TDFM-9100 and future host units. The external label will include the following text:
For TDFM-9300 “TDFM 9300 Multiband, “Contains IC: 120A-T6”
For TDFM-9200 “TDFM 9200 Multiband, “Contains IC: 120A-T6”
For TDFM-9100 “TDFM 9100 Multiband, “Contains IC: 120A-T6”
The Final host/module combination also need to be evaluated against the FCC Part 15B criteria
for unintentional radiators in order to be properly authorized for operation as a Part 15 digital
device.
SECTION 3: INSTALLATION INSTRUCTIONS