Installation and Operating Instructions

TECHNISONIC INDUSTRIES LIMITED

T6 Multiband Transceiver Module Operating Instructions

TiL 22RE638 Revision A

2.4 KNOB

The knob is a rotary encoder, which turns endlessly. The knob also has a push button

incorporated so you can press the knob as well. Pressing the knob will toggle through the

following possible knob modes:

Volume

Channel

Zone

NumLock

Recall

Band 3 (T6 module) only supports volume and channel knob modes.

The current function of the knob is shown at the bottom right of the display. Some of these modes

can be enabled or disabled in the Configuration Menu. The knob is only active for the band that is

selected.

2.5 SOFT KEYS AND HOME

The 3 soft keys below the display assume the function shown on the menu above them. The

functions displayed depend on how the module was programmed or which band is selected. The

T6 module on band 3 will always have the following menu items:

PWR

Selecting PWR will allow the power output of the radio to be set to high or low.

SCAN

Selecting SCAN will put the radio in scan mode. Channels that were added to the

scan list will be scanned.

FPP

Front Panel Programming mode allows you to program the frequencies, name, scan

list, PL tone and DPL code for the current channel. See section 2.11.

At any time while in one of these functions, it is possible to return to the normal mode by pressing

the HOME key.

2.6 BAND KEY

This button selects bands (RF modules) 1 through 5. The band displays are broken up into 3

pages. Page 1 = bands 1 and 2, page 2 = bands 3 and 4, page 3 = band 5. An arrow points at the

active band on the current page. The active band will also be highlighted for a few seconds while

changing bands.

2.7 MUP(4) AND MDN(7) KEYS (Memory Up and Down Keys)

These keys provide the same function as the rotary knob does when it is set to CHAN. These

keys can be used to scroll through the channels. A single press will step the channel by one, but

a push and hold will scroll to a desired channel number. The function of the rotary knob is

temporarily set to CHAN when either of these keys is pressed.

2.8 BRT(6) AND DIM(9) KEYS

Use these keys to dim or brighten the display. The radio powers up at full brightness for normal

use but can be dimmed for night operations.