Installation and Operating Instructions

TECHNISONIC INDUSTRIES LIMITED
T6 Multiband Transceiver Module Operating Instructions
TiL 22RE638 Revision A
2
2.1 GENERAL
An LED display, a keypad, and a rotary knob provide the operator control of RF modules installed
in the unit. The T6 module will always be band 3. The display shows the activity of the selected
module as well as the soft key menu of the active band. The active module is selected by
pressing the BAND key. The knob has multiple functions including volume, channel, and zone.
2.2 FRONT PANEL
Refer to the diagram below:
FIGURE 1: Front Panel Controls – TDFM-9100 Transceiver
2.3 POWER SWITCH
To switch the transceiver on, press and hold the knob until the radio powers up. The display will
show TECHNISONIC and the software version installed followed by the model number, and
which RF modules are installed. The display will then show the normal display. To switch off the
transceiver at any time, press and hold the knob for 2 seconds until the display shows OFF; then
release. If it is desired that the radio powers up with the radio master in the aircraft, an ‘always on’
mode can be set in the Configuration Menu.
SECTION 2: OPERATING INSTRUCTIONS