User's Manual

2-3
TDFM-600/6000 Transceiver Recommended Keypad Menu Defaults:
TDFM-600/6000
ITEM
Portable
ITEM
Conventional
Operation (H35)
SmartNet
Operation (H37)
SMARTZONE
Operation (H38)
F1 Key Top Side
Button 1
Monitor Phone Phone
F2 Key Center Side
Button 2
Scan Scan Scan
F3 Key Bottom Side
Button 3
Talkaround/
Direct
Private Call Site
Display/Search
F4 Key Orange (Top)
Button
Emergency Emergency Emergency
MUP and
MDN keys
16-Position
Rotary Knob
Channel Select Channel Select Channel Select
ESW Key Two-Position
Concentric or
Ergo Switch
Blank (O)
Low Power (∅)
Blank (O)
Low Power (∅)
Blank (O)
Low Power (∅)
TSW Key Three-Position
Toggle Switch
Blank (A)
Scan (B)
Blank (C)
Blank (A)
Scan (B)
Blank (C)
Blank (A)
Scan (B)
Blank (C)
Note: It is possible to use Motorola’s Radio Service Software (RSS™ or CPS™) to alter the default keypad settings
of the TDFM-600/6000 series radios. However if custom key settings are chosen it will not be possible for
Technisonic to help the Pilot or other Radio User through operational difficulties. These questions will have to
be referred to the Radio System Administrator responsible for customising the settings. Technisonic
recommends that the default key settings stay in place until all airframe installation and operational issues
have been overcome.
The TDFM-600/6000 series Transceivers are programmable by Motorola Radio Service Software. The following
settings may be programmed for each Channel in a Conventional Radio:
Tx Frequency Zone
Tx PL/DPL Code Channel
Rx Frequency Name
Rx PL/DPL Code RX Signal Voice Type
Time-Out Timer TX Signal Voice Type
Scan List Network Access Code
Phone Tx Power
Smart PTT