User's Manual
Table Of Contents
- Front Cover
- Foreword
- Table of Contents
- Foreword ii
- List of Figures vii
- List of Tables xi
- Commercial Warranty xiii
- Model Numbering, Charts, and Specifications xvii
- Chapter 1 Introduction 1-1
- Chapter 2 Radio Power 2-1
- Chapter 3 Theory of Operation 3-1
- Chapter 4 Troubleshooting Procedures 4-1
- Chapter 5 Troubleshooting Charts 5-1
- Chapter 6 Troubleshooting Waveforms 6-1
- Chapter 7 Troubleshooting Tables 7-1
- Chapter 8 Schematics, Board Overlays, and Parts Lists 8-1
- Appendix A Replacement Parts Ordering A-1
- Glossary Glossary-1
- Index Index-1
- List of Figures
- List of Tables
- Related Publications
- Commercial Warranty
- Model Numbering, Charts, and Specifications
- Portable Radio Model Numbering System
- ASTRO XTS5000 VHF Model Chart
- ASTRO XTS5000R (Ruggedized) VHF Model Chart
- ASTRO XTS5000 UHF Range 1 Model Chart
- ASTRO XTS5000R (Ruggedized) UHF Range 1 Model Chart
- ASTRO XTS5000 700–800MHz Model Chart
- ASTRO XTS5000R (Ruggedized) 700–800MHz Model Chart
- Specifications for VHF Radios
- Specifications for UHF Range 1 Radios
- Specifications for 700–800 MHz Radios
- Chapter 1 Introduction
- Chapter 2 Radio Power
- Chapter 4 Troubleshooting Procedures
- Chapter 5 Troubleshooting Charts
- 5.1 List of Troubleshooting Charts
- 5.2 Main Troubleshooting Flowchart
- 5.3 Power-Up Failure
- 5.4 DC Supply Failure
- 5.5 Display Failure (NNTN4563, NNTN4819, & NNTN4717 VOCON Kits)
- 5.6 Display Failure (NTN9564)
- 5.7 Volume Set Error
- 5.8 Channel/Zone Select Error
- 5.9 Button Test
- 5.10 Top/Side Button Test
- 5.11 VCO TX/RX Unlock
- 5.12 VOCON TX Audio
- 5.13 VOCON RX Audio
- 5.14 RX RF
- 5.15 TX RF (VHF)
- 5.16 TX RF (UHF R1/700-800MHz)
- 5.17 Keyload Failure
- 5.18 Secure Hardware Failure
- Chapter 6 Troubleshooting Waveforms
- Chapter 7 Troubleshooting Tables
- Appendix A Replacement Parts Ordering
- Glossary
- Index
- Back Cover
October 14, 2003 6881094C31-C
5-22 Troubleshooting Charts: VOCON RX Audio
VOCON RX Audio—Page 2
MAEPF-27395-O
Make sure that you look at
all solder contacts. Check
resistors and capacitors
associated with this check. If
all look fine, then replace U502.
Make sure that you look at
all solder contacts. Check
resistors and capacitors
associated with this check. If
all look fine, then replace U503.
Signal
Present?
Check Preamp
Output Signal
at C530
No
No
No
No
No
Ye s
Ye s
Ye s
Ye s
Ye s
1
Preamp Gain
= 2.8 V/V?
PA Gain
= 11.2 V/V?
Distortion
>3%?
Check Preamp
U502 and its
associated
components
Check Flex
Connector
Distortion
>3%?
Check Audio PA
U503 and its
Components