User's Manual

2-4
TDFM-600/6000
ITEM
XTS-3000
Portable
ITEM
Conventional
Operation (H35)
Smart Net
Operation (H37)
Smart Zone
Operation (H38)
F1 Key Top Side
Button 1
Monitor Phone Phone
F2 Key Center Side
Button 2
Scan Scan Scan
F3 Key Bottom Side
Button 3
Talkaround/
Direct
Private Call Site
Display/Search
F4 Key Orange (Top)
Button
Emergency Emergency Emergency
MUP and
MDN keys
16-Position
Rotary Knob
Channel Select Channel Select Channel Select
ESW Key Two-Position
Concentric or
Ergo Switch
Blank ( )
Low Power (ι)
Blank ( )
Low Power (ι)
Blank ( )
Low Power (ι)
TSW Key Three-Position
Toggle Switch
Blank (A)
Scan (B)
Blank (C)
Blank (A)
Scan (B)
Blank (C)
Blank (A)
Scan (B)
Blank (C)
Note: It is possible to use Motorola=s Radio Service Software (RSS or CPS) to alter the default
keypad settings of the TDFM-600/6000 series radios. However if custom key settings are
chosen it will not be possible for Technisonic to help the Pilot or other Radio User through
operational difficulties. These questions will have to be referred to the Radio System
Administrator responsible for customising the settings. Technisonic recommends that the
default key settings stay in place until all airframe installation and operational issues have been
overcome.
The TDFM-600/6000 series Transceivers are programmable by Motorola Radio Service Software. The
following settings may be programmed for each Channel in a Conventional Radio:
Tx Frequency Zone
Tx PL/DPL Code Channel
Rx Frequency Name
Rx PL/DPL Code RX Signal Voice Type
Time-Out Timer TX Signal Voice Type
Scan List Network Access Code
Phone Tx Power
Smart PTT
The following settings must be programmed for each mode in a Trunked (Smart Net or Smart Zone)
Radio:
System Type TG Strapping
System ID Zone
Individual ID Scan List