User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TMS-100 90-6R/8.33
Installation & Operating Instructions
TiL 02RE301 Rev B
3-6
3.5 OPERATION IN THE RECEIVE MODE
To operate the transceiver in the receive mode, proceed as follows:
(1) Ensure that the PRESS-TO-TALK switch on the microphone is NOT depressed, and
verify that the Tx ON yellow LED is OFF.
(2) Ensure that the PRESS-TO-TALK switch on the microphone is NOT depressed, and
verify that the Tx ON yellow LED is OFF.
(3) Adjust the SQUELCH control to suit location reception conditions. When the SQUELCH
control is rotated in the clockwise direction, the SQUELCH indicator green LED will go
ON, indicating that the squelch circuit is connecting the demodulated audio output to the
VOLUME control.
Further adjustment of the SQUELCH control determines the squelch setting.
(4) The VOLUME control can then be adjusted in a clockwise direction to increase the audio
level, or in a counter-clockwise direction to decrease the audio level which can be heard
on the internal loudspeaker.
NOTE:
When an external loudspeaker or headset is
connected to the SPEAKER/PHONE jack of the
transceiver, the internal loudspeaker is automatically
disconnected. The VOLUME control will now control
the audio level applied to the external loudspeaker or
headset, as applicable.
(5) To change the operating channel, set the CHANNEL switch to the desired channel 1
through 6, and verify that the appropriate CHANNEL INDICATOR green LED is ON.
3.6 SWITCHING OFF
To switch off the transceiver:
(1) Set the POWER ON/OFF switch to position 0, toggle down OFF position.
(2) Verify that all indicator LED's on the front panel are OFF.