Installation Guide

®
Installation Instructions For:
G3® Pathway Stabilizer
5660 Westside Road, Redding, CA 96001 USA Ph: 877-356-2250 Fax: [phone]
www.TechniSoil.com E-mail: [e-mail]
VIII. Existing Project Application Guidelines
Before treating an existing project, carefully consider the following;
• Surface layer material gradation, compaction, depth,
and age
• Subbase construction
• Edge restraint construction
• Previous modications of surface layer materials
If assessment of the previously stated variables coincides with
our ‘New Project’ guidelines, then proceed to next step.
• If assessment reveals issues that may adversely affect
the success rate of installation, then it is recommended
to renovate the project accordingly.
• Scarify upper 1” - 1.5” of surface using a tiller or rake.
Surface layer material should be broken apart as close
to its original gradation as possible. Clumped materials
or improper separation can result in poor stabilization
and compaction.
• Amend surface layer material with additional material
as needed to achieve proper slope, grade, crown, and/
or height. DO NOT COMPACT.
• Refer to recommended application guidelines.
IX. Storage
Store G3-PS out of direct sunlight in areas with a temperature
range of 55º - 90º F.
X. Maintenance
Treated areas should withstand normal conditions for 12 - 24
months before a maintenance coat is needed.
To rejuvenate and increase the life-span of the surface apply a
maintenance coat at approximately 150ft²/gallon.
If surface has been damaged, make any repairs to the surface
before applying a maintenance coat.
To repair a section of G3 pathway, place the appropriate amount
of crushed stone in a 5-gallon bucket and add enough G3-PS
to make a consistent mixture of aggregate chips and stone dust.
Mix aggregate and G3-PS with a dowel or paint stirrer and
apply the mixture to the repair area using a masonry trowel or
equivalent. Smooth the material to grade. Use a hand tamper to
compact into place.
Approximately 6 - 24 hours after repairing the surface, pour or
spray a light coating of G3-PS at 50ft
2
/gallon over the repaired
area. Cure time is within 24-72 hours or when the surface is dry
and solid.
XI. Warranty
TechniSoil Global, Inc. warrants this product to be free from
defects. Where permitted by law, TechniSoil makes no other
warranties with respect to this product, express or implied,
including without limitation the implied warranties of merchant-
ability or tness for particular purpose. The purchaser shall be
responsible to orchestrate their own tests to determine the suit-
ability of this product for their particular purpose. TechniSoil’s
liability shall be limited in all events to supplying sufcient prod-
uct to re-treat the specic areas to which product proven to be
defective has been applied. Acceptance and use of this product
absolves TechniSoil from any other liability, from any and all
sources, including liability for incidental, consequential or resul-
tant damages whether due to breach of warranty, negligence or
strict liability. This warranty may not be modied or extended by
representatives of TechniSoil, its distributors or dealers, inde-
pendent contractors, clients or end-users of any kind.