Operation Manual

5 Operation

5.1 Switching the TV set on and off

Switching the device on

> Switch the TV set on by pressing the On/Standby button on the remote control

or on the television.

Switching the device off

> Switch the device off by pressing the On/Standby button on the remote control

or on the television.

The device is now in standby mode.

The LED lights up red.

5.2 Selecting digital TV and radio programmes

Please note that the remote control must be switched to DVB mode to select digital TV

and radio programmes (DVB-S and DVB-T). To switch the remote control to DVB mode,

press the Digital button.

5.2.1 Using the programme up/down buttons

> Use the PROG +/- buttons either on the remote control to move up or down the

list one programme position at a time.

5.2.2 Using the number buttons

> Use the number buttons to enter the desired programme number.

For example:

1 for programme position 1

1, then 4 for programme position 14

2, then 3, then 4 for programme position 234

When entering programme numbers with more than one digit, you have about 3 seconds

after pressing each button to finish entering the entire number.

For example, if you would like to enter a one or two-digit number, you can speed up the

switching process by pressing and holding the last number.