Installation Instructions

11
EN
MONT
_
TechniLAN
_
4
_
4
_
aktiv
_
DE
_
EN.doc 04.09.2012 09:51 Seite 11
2 Safety Instructions
For your own protection, you should read through the safety precautions carefully prior to
installation. The manufacturer accepts no responsibility for damage caused by inappropriate
operation, or by non-compliance with safety precautions.
• The components must be assembled in a dry place, on a level and fire-resistant surface.
• Do not install the device into any roof insulation. Take care that the power supply has
sufficient air circulation.
• Install the device with the power switched off.
• The antenna system must be earthed.
• The antenna unit must be protected against lightning strikes in accordance with relevant
requirements.
• The relevant European standards and VDE (Association of German Electrical Engineers)
guidelines to guarantee electrical safety must be adhered.
• National legally required regulations governing broadcast receiving systems must be
adhered.
• Never open the unit housing.
Any intervention necessary should only be carried out by trained service personnel. In the
following cases, you should disconnect the unit from the mains power supply, and consult a
qualified technician:
• the unit was exposed to humidity, or liquid has run into the unit,
• in the event of malfunctions,
• in case of severe external damage.